Ryobi P521 Návod k obsluze stáhnout pdf (Strana 15)

OPERATION

Fig. 11

BASE

ANGLE CUTTING (BEVEL CUTTING)

See Figures 11 - 12.

Bevel cutting angles may be adjusted from 0° to 45° right

or left. Angles for cuts from 0° to 45° in 15° increments are

marked on a scale on both the left and right side of the base.

Notches on the rear of the base provide positive stops at

each of the above mentioned 15° increments. A protractor

is recommended when accurate cuts are required.

 Remove battery pack.

 Using the 1/8 in. hex key provided, loosen the base pivot

screws until the base can be moved.

 Slide base backward until base pivot screws can move

freely in slots in base.

 Align the mark, on the base, of the desired angle with the

edge of the motor housing.

 Once the desired angle is reached, slide base forward

until tab on motor housing aligns with the appropriate

notch on rear of base.

NOTE: When making a set-up for accurate cuts with

a protractor, or for angles other than the preset 15°

increments, the positive stop notches on the rear of the

base are not used.

 Tighten the base pivot screws securely.

 Return hex key to storage compartment.

 Replace battery pack.

NOTE: The wide slot in the base must be used when making

bevel cuts, scroll cuts, plunge cuts, and when cutting

metal.

PLUNGE CUTTING

See Figure 13.

WARNING:

To avoid loss of control, broken blades, or damage to

the material being cut, always use extreme caution when

making plunge cuts. We do not recommend plunge

cutting on materials other than wood.

 Mark the line of cut clearly on the workpiece.

 Set the cutting angle at 0°.

 Tilt the saw forward so that it rests on the front edge

of the base and blade will not come in contact with the

workpiece when the saw is turned on.

 Make sure the blade is inside the area to be cut.

 Using high speed, start the saw and slowly lower the

blade into the workpiece until the blade cuts through the

wood.

 Continue lowering the blade into the workpiece until the

base rests flat on the work surface, then move the saw

forward to complete the opening.

 Use only the 7 teeth per inch blade for this type of cut.

Fig. 12

SCALE

BASE

BASE PIVOT

SCREWS

HEX KEY

Fig. 13

1 2 ... 10 11 12 13 14 15 16 17 18

Komentáře k této Příručce

Norbert p Kurz 29 Nov 2024 | 23:12:20

Need a new battery

Ryobi P521 Návod k obsluze Strana 15

Komentáře k této Příručce

Související produkty a manuály pro Elektrické nářadí Ryobi P521