Ryobi DBJ50 Provozní pokyny stáhnout pdf (Strana 107)

Page 98 Power Equipment Usage Manual (Rev. 5/10)

c. Slide motor out of base.

d. Reassemble clamp screw, lock washer, flat washer, locking plate and clamp locking nut to base

and tighten lightly to prevent loss.

19.2.8. Installing & Removing the Bit

CAUTION: Be sure power switch is in the OFF position and tool is disconnected

from power source to avoid accidental starting of motor which could result in

personal injury.

a. Stand router upside down on its motor cap (see Figure

8).

b. Clean and insert shank of bit into collet until shank

bottoms. Then back it out approximately 3/8” to 1/2“.

c. Place one wrench on flats on chuck and one wrench on

collet nut (see Figure 8). Tighten firmly.

DO NOT ALLOW WRENCHES TO CONTACT COLUMNS

(A) Figure 9, AS COLUMNS MAY BE DAMAGED,

RESTRICTING PLUNGE ACTION.

NEVER TIGHTEN COLLET NUT WITHOUT BIT INSERTED.

TO DO SO MAY DAMAGE COLLET.

d. To remove bit, reverse the foregoing procedure. If bit

does not remove easily, tap the collet nut with wrench

to release bit.

19.2.9. Adjusting Plunge Base

CAUTION:

DISCONNECT TOOL

FROM POWER

SOURCE

a. Loosen depth rod locking

knob (A) Figure 10, and

depth indicator knob (D)

Figure 10, allowing the

depth rod (E) Figure 10,

to contact one of the turret stops (B) Figure 10.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 138 139

Žádné komentáře

Ryobi DBJ50 Provozní pokyny Strana 107