Ryobi TSS100L1 Uživatelský manuál stáhnout pdf (Strana 27)

27 — English

OPERATION

MAKING AN AUXILIARY FENCE

See Figure 35.

Certain unusual cuts may benefit from a thicker miter fence

(auxiliary fence) due to the size and position of the workpiece.

The holes provided in the miter fence are there for just this

purpose. The miter fence holes are used to secure the

auxiliary fence which requires a piece of wood 1/2 in. thick,

3-1/2 in. high, and 23 in. long to make.

NOTE: The auxiliary fence can only be used when the bevel

is set at 0°. When making a bevel cut, the auxiliary fence

MUST be removed.

To attach the auxiliary fence to the saw:

 Place the wood against the miter fence and mark the hole

location from behind the fence using a pencil.

 Drill holes through the wood then countersink the holes

on the front of the wood.

 Secure the wood to the miter fence using flat head

screws.

 With the miter table set at 0°, make a complete cut

through the auxiliary fence to create the blade slot.

NOTE: Check for interference between the auxiliary fence

and the lower blade guard. Correct any interference

before proceeding.

 Make a full 45° left miter cut and a 45° right miter cut

through the completed auxiliary fence.

AUXILIARY

FENCE

Fig. 35

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 99 100

Žádné komentáře

Ryobi TSS100L1 Uživatelský manuál Strana 27