Ryobi TSS100L1 Uživatelský manuál stáhnout pdf (Strana 14)

14 — English

ASSEMBLY

NOTE: Many of the illustrations in this manual show only

portions of the compound miter saw. This is intentional

so that we can clearly show points being made in the

illustrations. Never operate the saw without all guards

securely in place and in good operating condition.

LOCKING / UNLOCKING THE SAW ARM

See Figure 9.

To unlock and raise the saw arm:

 Firmly grasp the “D” handle and apply downward

pressure while at the same time pulling the lock pin out

and away from the saw housing. Rotate lock pin 90º to

lock (or unlock) the saw arm.

 Release the lock pin and slowly raise the saw arm.

To lock the saw arm:

 Firmly grasp the “D” handle and apply downward

pressure while at the same time pulling the lock pin out

and away from the saw housing.

 Release the lock pin allowing it to lock the saw into place.

DUST BAG

See Figure 10.

A dust bag is provided for use on this miter saw. It fits over

the exhaust port on the upper blade guard.

NOTE: the exhaust port also accepts 1-1/4 in. vacuum hose.

To install:

 Squeeze the two metal clips to open the mouth of the

bag and slide it on the exhaust port.

 Release the clips. The metal ring in the bag should lock

in between the grooves on the exhaust port.

To remove the dust bag for emptying:

 Reverse the above procedure.

Fig. 9

LOCK

“D”

HANDLE

Fig. 10

DUST

BAG

EXHAUST

PORT

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

Žádné komentáře

Ryobi TSS100L1 Uživatelský manuál Strana 14