Ryobi 310BVr Uživatelský manuál stáhnout pdf (Strana 12)

OIL AND FUEL INFORMATION

OIL AND FUEL MIXING INSTRUCTIONS

Old and/or improperly mixed fuel are the main reasons

for the unit not running properly. Be sure to use fresh,

clean unleaded fuel. Follow the instructions carefully for

the proper fuel/oil mixture.

Definition of Blended Fuels

Today's fuels are often a blend of gasoline and

oxygenates such as ethanol, methanol, or MTBE (ether).

Alcohol-blended fuel absorbs water. As little as 1 % water

in the fuel can make fuel and oil separate. It forms acids

when stored. When using alcohol-blended fuel, use fresh

fuel (less than 60 days old).

Using Blended Fuels

If you choose to use a blended fuel, or its use is

unavoidable, follow recommended precautions.

• Always use fresh fuel mix per your operator's manual.

• Always agitate the fuel mix before fueling the unit.

• Drain the tank and run the engine dry before storing

the unit.

Using Fuei Additives

The bottle of Ryobi 2-Cycle Oil that came with your unit

contains a fuel additive which will help inhibit corrosion

and minimize the formation of gum deposits. It is

recommended that you use only Ryobi 2-Cycle Oil with

this unit.

If unavailable, use a good 2-cycle oil designed for

air-cooled engines along with a fuel additive, such as

STA-BIL® Gas Stabilizer or an equivalent. Add 0.8 oz.

(23 ml.) of fuel additive per gallon of fuel according to the

instructions on the container. NEVER add fuel additives

directly to the unit's fuel tank.

CAUTION: For proper engine operation and

maximum reliability, pay strict attention to

the oil and fuel mixing instructions on the 2-

cycle oil container. Using improperly mixed

fuel can severely damage the engine.

Thoroughly mix the proper ratio of 2-cycle engine oil with

unleaded gasoline in a separate fuel can. Use a 32:1

fuel/oil ratio. Do not mix them directly in the engine fuel

tank. See the table below for specific gas and oil mixing

ratios.

NOTE: One gallon (3.8 liters) of unleaded gasoline mixed

with one 4 oz. (120 ml.) bottle of Ryobi

2-Cycle Oil makes a 32:1 fuel/oil ratio.

UNLEADED GAS

RYOBI 2 CYCLE OIL

1 US. GALLON + 4.0 FL. OZ.

(3.8 LITERS) (120 ml)

1 LITER + 30 ml

MIXING RATIO - 32:1

WARNING: Gasoline is extremely

flammable. Ignited vapors may explode.

Always stop the engine and allow it to cool

before filling the fuel tank. Do not smoke

while filling the tank. Keep sparks and open

flames at a distance from the area.

WARNING: Remove fuel cap slowly to avoid

injury from fuel spray. Never operate the unit

without the fuel cap securely in place.

WARNING: Add fuel in a clean, well-

ventilated area outdoors. Wipe up any spilled

fuel immediately. Avoid creating a source of

ignition for spilled fuel. Do not start the

engine until fuel vapors dissipate.

NOTE: Dispose of the old fuel/oil mix in accordance to

Federal, state, and local regulations.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Komentáře k této Příručce

Žádné komentáře

Ryobi 310BVr Uživatelský manuál Strana 12

Komentáře k této Příručce

Související produkty a manuály pro Větráky Ryobi 310BVr