Ryobi DP121 Uživatelský manuál stáhnout pdf (Strana 15)

ASSEMBLY

Fig. 11

HEAD

ASSEMBLY

INSTALLING CHUCK, HEAD ASSEMBLY, AND

FEED HANDLES

See Figures 9 - 11.

NOTE: Move the table out of the way before beginning

installation.

Position the head assembly onto the column with the

chuck positioned over the table.

NOTE: The head assembly is heavy. Get help when

needed.

Slide the head assembly down as far as it will go. Align

the head assembly with the base then tighten the two

head set screws with the hex key.

Attach the three feed handles by screwing them into the

threaded holes in the hub.

Position chuck on arbor. Chuck should be fully opened

to avoid damaging jaws.

Using a piece of scrap wood to protect the chuck, firmly

tap the chuck into place using a mallet or hammer.

Fit the arbor into the spindle shaft turning it to the right

until it slips into place and tap with mallet using a piece

of wood.

NOTE: Wipe the surfaces of the arbor and spindle shaft

with a clean, dry cloth before assembly to remove excess

grease. Do not use a chemical cleaning agent.

SET

SCREWS

FEED

HANDLE

Fig. 10

Fig. 9

HUB

CHUCK

ARBOR

HEAD

ASSEMBLY

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Žádné komentáře

Ryobi DP121 Uživatelský manuál Strana 15