Ryobi YN200BND Návod k obsluze Strana 14

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 44
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 13
TROUBLESHOOTING
Air leak near the top of the tool or
in the trigger area
PROBLEM POSSIBLE CAUSE SOLUTION
Loose screws
Worn or damaged O-rings or
seals
Tool does nothing or operates
sluggishly
Tool jams frequently
Tighten screws
InstallOverhaulKit
Inadequate air supply
Inadequate lubrication
Worn or damaged O-rings or bumper
InstallOverhaulKit
Verify adequate air supply
Lubricate tool
InstallOverhaulKit
Air leak near the bottom of the
tool
Worn or damaged O-rings or bumper
Incorrect fasteners
Damaged fasteners
Loose magazine
Dirty magazine
Worn or damaged driver
Verify that fasteners are the correct size
Replace fasteners
Tighten screws
Clean magazine
InstallDriverMaintenanceKit
14 - English
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 15
AFTER SPANISH LANGUAGE SECTION.
Zobrazit stránku 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Komentáře k této Příručce

Žádné komentáře