Ryobi ELL0006 Uživatelský manuál

OPERATOR’S MANUALAIRgrip™ ProCross™ LASER LEVELSELF-LEVELING ELL0006SAVE THIS MANUAL FOR FUTURE REFERENCEYour laser level has been engineered and man

10OPERATIONROUGH SURFACE ADAPTORSee Figure 7.By using the rough surface adaptor, you can use the AIRgrip feature to position the unit on many non-smoo

11OPERATIONFig. 11USING A TRIPODSee Figure 10.The laser level has a 5/8 in.-20 threaded fitting for attaching to a tripod base (not included). This

12MODEL NO. ELL0006 WAVE LENGTH: 630-670 NM MAX. POWER OUTPUT < 5MW CLASS IIIA LASER PRODUCT LASER RADIATION- AVOID DIRECT EYE EXPOSURE Complies

13TROUBLESHOOTINGProblem Possible Cause SolutionVacuum not running. Batteries are low.Power is turned off.Replace batteries.Press on/off button.Laser

ONE WORLD TECHNOLOGIES, INC.1428 Pearman Dairy RoadAnderson, SC 29625Phone 1-800-525-2579www.ryobitools.comOPERATOR’S MANUALAIRgrip™ ProCross™ LASER

2 Introduction ...

3GENERAL SAFETY RULESWARNING!READ AND UNDERSTAND ALL INSTRUCTIONS. Fail-ure to follow all instructions listed below, may result in electric shock, fir

4SYMBOLSSome of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of

5SERVICEThis unit has no serviceable parts. If the unit fails due to normal wear and tear within two years of purchase, return with original rece

6FEATURESFig. 1PRODUCT SPECIFICATIONSRecommended Use...

7FEATURESKNOW YOUR CROSSHAIR LASER LEVELSee Figures 1 - 2.The safe use of this product requires an understanding of the information on the product and

8ASSEMBLYUNPACKINGThis product has been shipped completely assembled. Carefully remove the product and any accessories from the box. Make sure that

9OPERATIONRotate the laser lens housing until the battery compart-ment comes into view. Remove battery cover plate.Install two AA batteries acco