Ryobi 180r Uživatelský manuál

MODEL 180r and 190rELECTRIC BLOWER/VACOPERATOR’S MANUALFOR QUESTIONS, CALL 1-800-345-8746 in U.S.OR 1-800-265-6778 in CANADAIMPORTANT MANUAL DO NOT TH

10OPERATING INSTRUCTIONSSTARTING AND STOPPING THEBLOWER/VACThis unit is equipped with an OFF/LOW/HIGHswitch (Fig. 15). For low speed operation, slidet

11WARNING: To avoid seriouspersonal injury, wear goggles or safetyglasses at all times when operating this unit. Wear a face mask or dustmask in dusty

12SERVICING OF DOUBLE-INSULATED UNITSThis unit is double-insulated. In a double-insulated unit, two systems of insulation areprovided instead of groun

NOTES13SPECIFICATIONSMotor Amperage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9.5 Amps-Model 180r12 Amps-Model 190r

RYOBI OUTDOOR PRODUCTS warrants eachnew RYOBI Product for two (2) years accordingto the following terms.This warranty extends to the original retailpu

2TABLE OF CONTENTS INTRODUCTION THANK YOUThank you for purchasing this quality product. This modern outdoor power tool is designed toprovide many hour

SAFETY WARNINGS3THE PURPOSE OF SAFETY SYMBOLS IS TOATTRACT YOUR ATTENTION TO POSSIBLEDANGERS. THE SAFETY SYMBOLS, AND THEEXPLANATIONS WITH THEM, DESER

SAFETY WARNINGS4• A nameplate on your unit indicates whatvoltage it uses. Never connect the unit to anAC voltage that differs from this voltage.• Insp

SAFETY WARNINGS5• Do not wear loose fitting clothing or articlessuch as scarves, strings, chains, ties, etc.,because they could get drawn into the air

6SAFETY AND INTERNATIONAL SYMBOLSThis operator's manual describes safety and international symbols and pictographs that mayappear on this product

ASSEMBLY INSTRUCTIONS7Fig. 1Fig. 4Fig. 2NOTE: The blower tube and nozzle orconcentrator tube must be used at alltimes when in blower mode to preventth

8ASSEMBLY INSTRUCTIONSFig. 94. Slide the lower vacuum tube into the uppervacuum tube. The arrow on the lowervacuum tube should align with the arrowon

9ASSEMBLY INSTRUCTIONS8. Close the zipper on the bag (Fig. 11).9. Align the vacuum bag/elbow tube assemblywith the grooves on the motor housing(Figs.