Ryobi SS180 Návod k obsluze stáhnout pdf (Strana 12)

OPERATION

USING CIRCLE CUTTER

See Figure 10.

Follow these directions when using the circle cutter.

■ Assemble circle cutter if necessary. Refer to “AS-

SEMBLING CIRCLE CUTTER” earlier in this manual.

■ Attach circle cutter to Speed Saw if necessary. Refer

to “ATTACHING CIRCLE CUTTER” earlier in this

manual.

■ Adjust depth of cut if necessary. Refer to “ADJUST-

ING DEPTH OF CUT” earlier in this manual.

■ Loosen pivot point knob.

■ Move pivot point knob to desired diameter dimen-

sion.

■ Tighten pivot point knob.

■ Start Speed Saw.

■ Cut a pilot hole in the center of the intended circle.

■ Line up pivot point knob with the lead hole.

■ Begin cut, applying moderate, steady pressure.

■ Hold the Speed Saw firmly with one hand and the

handle with the other.

CAUTION:

Too much force causes heat build up, which can

shorten the life of the bit.

■ Work in a clockwise direction, continuing back to the

starting position.

■ Stop Speed Saw.

Fig. 10

1 2 ... 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

Ryobi SS180 Návod k obsluze Strana 12