Ryobi RY34007 Uživatelský manuál stáhnout pdf

WARNING: This Engine Starting Procedure is not a substitute for

reading the operator’s manual. To reduce the risk of injury, user must

read and understand operator’s manual before using this product.

Go to www.ryobitools.com and register your new tool on-line. For any questions about

operating or maintaining your product, call the Ryobi

Help Line! Your Product has been

fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips

are also available in your operator’s manual. For additional registration instruction, refer

to operator’s manual.

First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided.

Later uses: Check engine lubricant level and add lubricant if needed.

Carefully pour fuel into the tank. Avoid spillage.

Immediately replace fuel cap and hand tighten.

Wipe up any fuel spillage.

PRIME press the PRIMER BULB 10 times

slowly.

SET CHOKE lever to “ FULL CHOKE “

position. Do not squeeze throttle trigger.

Press the PRIMER BULB 10 times

slowly. Set choke lever to RUN. Pull

starter grip until the engine runs.

DEPRESS the “STOP” switch to the STOP position

Warm Engine:

After 10 seconds, SET CHOKE lever to RUN

position.

Cold Engine:

To Stop:

With throttle at idle, PULL starter grip sharply

until engine runs. (Max 3 times)

• If 60°F or lower, continue to pull starter grip until

engine runs.

• If above 60°F, set CHOKE lever to “HALF

CHOKE” and pull starter grip until engine runs.

ENGINE STARTING PROCEDURE

LUBRICANT

1 GALLON

GAS

10x

HALF

CHOKE

RUN

10x

RUN

FULL

CHOKE

RUN

HALF

CHOKE

NOTICE

Do not use E15 or E85 fuel (or fuel

containing greater than 10% ethanol) in

this product. It is a violation of federal

law and will damage the unit and void

your warranty.

CALL

1-800-860-4050

www.ryobitools.com

990000697

8-6-13 (REV:01)

1 2

Shrnutí obsahu

Strany 1 - ENGINE STARTING PROCEDURE

WARNING: This Engine Starting Procedure is not a substitute for reading the operator’s manual. To reduce the risk of injury, user must read and unders

Strany 2 - 1-800-860-4050

AVERTISSEMENT : Cette procédure de démarrage du moteur n’est pas un substitut au manuel d’utilisation, qu’il importe de lire. Pour réduire les risques