Ryobi D40 Návod k obsluze stáhnout pdf

THANK YOU FOR BUYING A RYOBI DRILL-DRIVER

Your new drill has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation,

and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance.

CAUTION: Carefully read through this entire operator's manual before using your new drill-driver.

Pay close attention to the Rules for Safe Operation, Warnings, and Cautions. If you use your drill properly and only

for what it is intended, you will enjoy years of safe, reliable service.

Thank you again for buying Ryobi tools.

OPERATOR'S MANUAL

3/8 in. (10 mm) Drill-Driver

Model No. D40

DOUBLE INSULATED

SAVE THIS MANUAL FOR FUTURE REFERENCE

1 2 3 4 5 6 ... 13 14

Shrnutí obsahu

Strany 1 - Model No. D40

THANK YOU FOR BUYING A RYOBI DRILL-DRIVERYour new drill has been engineered and manufactured to Ryobi's high standard for dependability, ease of

Strany 2 - WARNING:

10OPERATIONLEVEL DRILLINGSee Figures 6 and 7.Two levels are recessed in the motor housing of yourdrill. One is located on top, while the other is loca

Strany 3 - GENERAL SAFETY RULES

11MAINTENANCEGENERALAll parts represent an important part of the doubleinsulation system and should be serviced only at anauthorized service center.Av

Strany 4 - SPECIFIC SAFETY RULES

12NOTES

Strany 5 - SAVE THESE INSTRUCTIONS

13RYOBI 3/8 in. DRILL-DRIVER – MODEL NO. D40The model number will be found on a plate attached to the motor housing. Always mention themodel number in

Strany 6 - FEATURES

983000-032 OPERATOR'S MANUAL3/8 in. (10 mm) Drill-DriverModel No. D40DOUBLE INSULATED• SERVICENow that you have purchased your tool, should

Strany 7

2INTRODUCTION Table of Contents / Introduction ...

Strany 8

3GENERAL SAFETY RULESWARNING:Read and understand all instructions. Failure to fol-low all instructions listed below, may result in elec-tric shock, fi

Strany 9

4SPECIFIC SAFETY RULESHold tool by insulated gripping surfaces when performing an operation where the cutting tool may contacthidden wiring or its cor

Strany 10 - OPERATION

5SAVE THESE INSTRUCTIONSSYMBOLSImportant: Some of the following symbols may be used on your tool. Please study them and learn their meaning.Proper int

Strany 11 - MAINTENANCE

6KNOW YOUR DRILL-DRIVERSee Figure 1.Before attempting to operate your drill, familiarize yourselfwith all operating features and safety requirements.W

Strany 12

7FEATURESPRODUCT SPECIFICATIONS:DRILL-DRIVER D40Chuck Capacity 1/16 in. to 3/8 in.(1.6 mm to 10 mm)Rating 120 V, 60 Hz, AC onlyInput 4.5 AmperesSwitch

Strany 13 - PARTS LIST

8OPERATIONREVERSIBLESee Figure 3.FORWARDFig. 3REVERSEThis tool has the feature of being reversible. Thedirection of rotation is controlled by a select

Strany 14

9OPERATIONWARNING:Make sure to insert drill bit straight into chuck jaws.Do not insert drill bit into chuck jaws at an angle andthen tighten, as shown